Snappi System User Manual
Document No: 053-05 v29
Page 35 of 75
December 2015
Snappi System User Manual.doc
5.7 Final checks
1. IMPORTANT:
In order to ensure that the Butterfly (Chest) or H-Belt harness cannot
rise up and cause harm to the user, every time the harness is in use, you must
ensure that all cam buckles/fixings are properly closed and that the harness is
correctly positioned a minimum of 75mm below the user’s neckline. Failure to
comply with this could result in serious injury.
2. Check that the pelvic strap is secure and adjusted correctly.
3. Check that the cover is correctly fitted.
4. Check that the seat unit is located and locked correctly in the chassis.
5. Ensure the safety catch is locked.
6. Position the child correctly in the seat, and assess the child's posture, if the child's
posture appears to have changed remove the child and compare the support
positions to the measurements taken in section 5.1. Adjust the supports as
required, and reseat the child.
7. Check footplate position and adjust if necessary.
Fig 5.6.10
Using a 6mm Allen Key and a 10m spanner undo the
nut (nearest to the base of the seat) and remove the
nut and washer. Place the folded end of the bottom
harness strap through the bolt using the pre-drilled
hole. Ensure the strap is flat then replace washer and
nut, retighten the nut. (Fig 5.6.10)
Twist the cam buckle back into
its original position (Fig 5.6.11)
Fig 5.6.11
Cam buckle returned
to original position
Folded over end of harness bottom strap.
Re-tightened nut
