Snappi System User Manual
Document No: 053-05 v29
Page 30 of 75
December 2015
Snappi System User Manual.doc
To fit the 2-point pelvic strap to the new-
style Snappi, (which has 3 cam buckles on
each side:
Open the middle cam-lock buckles (these
are located on the bottom left and right
corners of the seat base).
Feed the webbing of the strap between the
seat plate and seat depth adjustment tube,
and through the cam lock. (See Fig 5.4.5)
Fig 5.4.5
Fig 5.4.6
Adjust the length of the pelvic strap by
pulling the webbing through the cam buckle
until it is at the required length. (Fig 5.4.6)
Once adjusted, lock the buckles on both
sides of the seat to secure the strap.
Important:
The pelvic strap must be located
as low down over the hips as possible. It
must not cross the stomach of the
passenger.
To fit the 4-point pelvic strap to the new-
style Snappi, (which has 3 cam buckles on
each side:
Open the middle and front cam-lock
buckles.
Feed the top webbing straps (See Fig 5.4.2)
between the seat plate and seat depth
adjustment tubes and through the middle
cam lock. (See Fig 5.4.5)
Feed the bottom webbing straps through the
slot at the bottom of the Hip Guide plates,
over the seat depth adjustment tubes and
through the front cam lock. (See Fig 5.4.7)
Fig 5.4.7
