TSP Edge User’s Manual
40-400-00065, Rev. E
36
Signaling Type
This option cannot be changed. This may be enabled for future enhancements.
Default Timings Set
The choices of Emulation and Dialed are used in conjunction with the Controls Set
type chosen. Emulation is the default and is used in all but Dialed Control Sets. When
using Dialed Control Sets, choose the Dialed Default Timing Set. The Timings
default values are set differently to accommodate for the call progress differences in
the Control Sets. For more information, see “Control Sets” on page 40.
Dial Tone
The Dial Tone feature only applies to FXS protocols. The Edge defaults to providing
Dial Tone on the channel. You can disable Dial Tone by clearing the Dial Tone check
box.
Ringback
The Ringback feature applies to FXS, Delay Dial, Immediate Dial, Wink Start, E1
ITU Q.421, and PRI Network protocols. The Edge defaults to providing ringback on
the channel. You can disable Ringback by clearing the Ringback check box.
Hook Flash Detect
This option allows detection of hook flash to perform transfers. It only allows
transfers between analog FXS lines in a dialed control set.
Trunk Type
This option gives the choice of Tie Trunk or CAMA for T1/E1 Wink Start, Delay
Dial, and Immediate Dial. Tie Trunk is for end-to-end signaling. CAMA operation is
where a signaling is done section by section.
Timings Tab
Timings are used to control the intervals of all the different parts of the call process
while the Edge is originating or terminating calls. The default times should be
appropriate for most testing.
There are three sections on the Timings screen:
•
Timings in the
Originating Calls
section are used when the Edge is generating
calls to the equipment under test.
•
Timings in the
Terminating Calls
section are used when the Edge is receiving
incoming calls from the equipment under test.
•
Timings in the
All Calls
section apply to both incoming and outgoing calls.
See “Call Timings and Process Flowcharts” on page 125 for a detailed description of
each parameter.
