Stop Section
The
Stop
section has the choices of
Time
,
Elapsed Time
,
Number of Calls
, and
Manual
.
Selecting the radio button next to
Time
enables a field to set a predefined time for the TSP to stop
testing. Choosing
Elapsed Time
enables a field to set the amount of time (in hours and minutes)
the test is to run once started. The
Number of Calls
option is used to set a specific number of
calls to be placed to each of the channels assigned. Using the
Manual
option stops the test once
the
Control Set Enable
button is disabled from the main TSP screen. Go to “Executing a
Simulation” section to run the Control Set.
Click
OK
to go back to the TSP main screen.
Executing a Simulation
Starting/Stopping a simulation is accomplished with a
Control Set Enable
button
.
Once a Control
Set is created, a button will appear under
Control Sets Enables
on the right side of the screen.
Activation of this button will start a simulation and the
(disabled) next to the
Control Set
name
will change to a
, (running) signifying that the simulation is running. Upon completion of a timed
application, the
(running) will change to a
(finished). Manually stopping the simulation by
clicking on the
Control Set Enable
button, causes the
to re-appear next to the
Control Set
name after all the assigned channels return to an idle state.
Figure 28 shows a
Control Set Enable
button with the name “
Control Set Example”
on the main
TSP
screen at the far right.
Figure 28 Control Set Information
When expanding the display tree for Control Sets and highlighting the name of the Control Set, a
list of the
Parameters
and
Values
will be displayed in the information section to the right of the
Programming the TSP
40-400-00049, Rev. J
Page 39
