screen by clicking on
New
and creating the template as discussed in the Template section.
Either choose a previously created Template from the drop down box or create a new Template
by clicking
New
. This tells the TSP the type of channel protocol it will be using for initiating calls to
the equipment under test.
For End-to-End Control Sets, the
Control Set
screen will show two template fields instead of one.
This allows you to assign a template to each of the two channels that you are connecting. Refer
to Figure 25.
The next step is to assign the channels.
Channel Assignments
To select the channels, click on the
Edit Channels
button (see Figure 25)
.
The
Channel
Assignments
screen will come up. See Figure 26.
Figure 26 Channel Assignments Screen (Analog)
The
Channel Assignments
screen shows the
Available Channels
to test for the Control Set Type
and Template name chosen on the
Control Set
screen. In the example, for an Analog LS Channel
Type, the name “
Analog LS
” was given to the Template. Notice that in the
Channel Assignment
screen on the left side under
Available Channels
, the Template name,
Analog LS
is shown. Listed
underneath are the channels that can be used for the Control Set and Template chosen. The
Channel Identification plus the Card Type for the Template are shown here.
Add/Remove buttons
The channels to be tested are chosen by selecting the channel on the left side and clicking the
Add button or by dragging and dropping to the right side of the screen under the
Template
name.
To remove a channel on the right, select it and click on the
Remove
button or drag and drop back
to the left side of the screen. Multiple channels can be done simultaneously by using the shift or
Programming the TSP
40-400-00049, Rev. J
Page 37
