Channel Configuration Wizard
Click on the
Wizard
button under
Channel Configuration
. The
Channel Configuration Wizard
screen will come up.
Figure 20 Channel Configuration Wizard Screen
This screen can be used to automatically assign
Phone Number
,
Transmit Digits,
and
Audio
Message
for all the channels on that card type all at once either by
Slot+Port+Channel
or
Increments
. These fields are the same as on the
Slot
tab for the
Unit
screen under
Channel
Configuration
and can be done either way.
For assigning
Phone Number
or
Transmit Digits
on the
Channel Configuration Wizard
screen, the
defaults can be used for the
Starting Number
field or a specific number can be put in that field.
Slot+Port+Channel
will assign the last four digits according to the TSP Channel Configuration.
Clicking on the down arrow to the right of
Slot+Port+Channel
gives the
Increment
option.
Choosing this will enable the
Increment
field which can be changed by using the up and down
arrow to the right or by typing the
Increment
number into the field. In this case, the last four digits
will need to be added in the Starting Number screen. A completely different number can also be
used. Whatever number is used, each channel will be given the
Starting Number
plus the
Increment
used. (i.e., Starting Number 12345678901 for Increment of 3. Channel 1-
12345678901, channel 2- 12345678904, channel 3- 12345678907, channel 4- 12345678910,
etc.)
The wizard will assign the
Audio Message
selection to all the channels on that module.
Click
OK
at the bottom of the
Channel Configuration Wizard
screen when finished with the
settings. Remember, all these settings can also be done manually for a specific channel at the
Unit
screen on the
Slot
tab under
Channel Configuration
.
Once configurations are completed on the
Units
screen, click
OK
at the bottom left. The
programming information will automatically be sent to the TSP.
Note:
If manually configuring the card types on the TSP, and an error message “Installed card types do
not match defined card types” comes up. This indicates a configuration mismatch between the
modules and Card Types selected in the program. If this message occurs, click
OK
and go back
to the
Units
screen and choose the name of the TSP to edit. Verify and correct the settings.
Programming the TSP
40-400-00049, Rev. J
Page 27