Channels Tab
The
Channels
tab is where each channel can be assigned a
Phone Number
,
Transmit Digits
(T1/E1 only) and
Audio Message
. The
Channel Configuration
gives the channel an assignment
number based on the name the unit was given, the slot number the module is in, the port (each
physical connector on a card is considered a port and is numbered on the card), and the logical
channel (1-24 on a T1, 1-30 on an E1, 1-2 on an 8 Channel POTS and only 1 on a 4 Channel
POTS).
The
Subaddress
,
Calling Number
, and
Called Number
fields are only available for
T1-PRI
card
mode. See TSP-PRI section of the manual.
Note:
For E1, only usable channels are listed (1-30). The 2 signaling channels will not be available.
Channel Identification
Clarification of the assignment method is displayed below:
For POTS channels (see Figure 19), note the numbering scheme by clicking on the arrow under
Channel Configuration
on the POTS screen. The channel displayed in the figure is
Unit Example
.3.1.01
. The name assigned is
Unit Example
with
.3
being the third Slot in the TSP. The
.1
is the
first port of four on the POTS module. The
.01
is for the first channel of two on each port of the 8
Channel POTS module. Note that the breakdown for the channel assignment is displayed just
beneath the Channel Configuration box on the POTS screen.
If you are using a T1/E1 module select the appropriate
Slot
tab. To select a channel, click on the
arrow located under
Channel Configuration
and choose the channel. Due to the number of
channels on a Single T1 (24) or a Dual T1 (48), it will be necessary to scroll to see all the
channels. You can also scroll by clicking on the up and down arrows just to the right of the arrow.
On a Dual T1/E1 module, the last channel number is “Unit Name” .2.2.24.
Unit name
, being the
name given to the TSP unit. The first
.2
being the second slot of four in the TSP. The second
.2
is
for the second RJ port of two on the Dual T1/E1 module and
.24
is the last channel of twenty-four
on the second T1. This is used to assign
Transmit Digits
, and
Audio Message
for the specific
channel chosen.
All the parameters available for the T1/E1 cards under the
Channel Configuration
are identical on
the
4 and 8 Channel POTS Type
screens, except for
Transmit Digits
which is only available on
T1/E1.
Phone Number
The
Phone Number
is the telephone number assigned (up to 40 digits) to a channel that will be
dialed by another channel to call to that channel. This only applies to the Dialed Control Set Type.
See Dialed Control Sets section for more details.
Transmit Digits
The
Transmit Digits
are the DTMF digits (up to 40 digits) that the TSP will send digitally via
common channel for PRI calls or in-band when a call is placed to a T1/E1 Wink Start, Delay Dial,
Programming the TSP
40-400-00049, Rev. J
Page 25
Unit Example . 3 . 1 . 01
Unit Name
Port Number
Slot Number
Channel Number
