tree for the Control Set. See Figure 28. The same can also be done for all the other components
on the display tree to display configurations.
Testing is started by clicking on the
Control Set Enable
button. The button will appear depressed
when enabled and a small
will appear next to the Control Set name. See Figure 29. Since the
Control Set in Figures 28 and 29, was configured for
Manual Start
and
Stop
, the test calls will
start immediately and will not stop until the
Control Set Enables
button is clicked a second time.
Figure 29 POTS Call Status
Call Status Symbols
For POTS channels the status of the channel will change from
(on-hook) to
(ringing) to
indicate a ringing state. Once the TSP recognizes an off-hook from the equipment under test, the
(ringing) will change to an
(off-hook). See Figure 29. This is the state of the equipment
under test.
Telecom Simulation Platform
Page 40
Active control set
Off-hook
