Tektronix WFM 601i, User Manual

Page: 35 / 135

WFM 601i Serial Component Monitor
1–17
Functional Check
The following procedure is provided to aid in obtaining a display on the
WFM 601i Serial Component Monitor. It is designed for operator familiarization
and as a check of basic instrument operation. Only instrument functions, not
measurement quantities or specifications, are checked in this procedure.
Therefore, a minimum amount of test equipment is required.
WARNING. Be sure that the cabinet is installed on the instrument to avoid
personal injury.
All checks are made with the cabinet installed. The cabinet, an optional
accessory, must be installed on the instrument to avoid personal injury, maintain
proper environment for the instrument, keep dust out, and provide proper EMI
shielding.
NOTE
. Unless otherwise noted, the waveforms shown in this procedure are
representations of actual displays on the WFM 601i.
If performing the Functional Check reveals improper operation or instrument
malfunction, first check the operation of the associated equipment. If it is
operating normally but the WFM 601i is not, then refer the instrument to
qualified service personnel for repair or adjustment.
When a complete check of the instrument performance to specification is
desired, refer qualified service personnel to the Performance Verification
procedure in the Service manual.
Required Equipment
The following equipment is required to perform this procedure:
1. Digital Component Television Signal Generator to provide:
Color bar, Luminance Staircase, and Component Timing signal (Bowtie).
For example: Tektronix TSG-422 Digital Component Generator, Option 1S
(Serial Digital output); the 422 generator was used to prepare this procedure.
2. Coaxial Cables
1 — 42-inch 75 RG6 type cable (Tektronix Part No. 012-0159-00)
3. 75 Terminators
1 — End-line (Tektronix Part No. 011-0163-00)