Tektronix WCA230A, Programmer'S Manual

Page: 63 / 678

Command Groups
WCA230A & WCA280A Programmer Manual
2- 37
:TRACe Commands
Set up display of Trace 1 and 2.
Table 2- 27: :TRACe commands
Header Description
:TRACe<x>|:DATA<x>:AVERage:CLEar Restarts trace averaging.
:TRACe<x>|:DATA<x>:AVERage:COUNt(?) Sets the number of traces to combine for averaging.
:TRACe<x>|:DATA<x>:DDETector(?) Selects the display detector.
:TRACe<x>|:DATA<x>:MODE(?) Selects the way to display the traces.
:TRACe2|:DATA2:MODE(?) Selects how to display Trace 2 in the signal source analysis.
:TRIGger Commands
Set up the trigger.
Table 2- 28: :TRIGger commands
Header Description
:TRIGger[:SEQuence]:LEVel:EXTernal(?)
(S/N B020000 and above)
Sets the external trigger level.
:TRIGger[:SEQuence]:LEVel:IF(?)
(S/N below B020000 and J300100 and above)
Sets the IF trigger level.
:TRIGger[:SEQuence]:LEVel:IQFRequency(?)
(Option 02 only)
Sets the IQ frequency trigger level.
:TRIGger[:SEQuence]:LEVel:IQTime(?) Sets the IQ time trigger level.
:TRIGger[:SEQuence]:MODE(?) Selects the trigger mode.
:TRIGger[:SEQuence]:MPOSition? Queries the trigger occurrence point in one block data on the memory.
:TRIGger[:SEQuence]:OPOSition? Queries the trigger output point.
:TRIGger[:SEQuence]:POSition(?) Sets the trigger position.
:TRIGger[:SEQuence]:SAVE:COUNt[:STATe](?) Determines whether to limit the number of times that data is saved.
:TRIGger[:SEQuence]:SAVE:COUNt:MAXimum(?) Sets a limit on the number of times that data is saved.
:TRIGger[:SEQuence]:SAVE[:STATe](?) Determines whether to enable or disable the Save-on-Trigger function.
:TRIGger[:SEQuence]:SLOPe(?) Selects the trigger slope.
:TRIGger[:SEQuence]:SOURce(?) Selects the trigger source.