Tektronix DSA8200 Series, Service Manual

Page: 137 / 196

Removal and Installation Procedures
DSA8200 Digital Serial Analyzer and Modules Service Manual
4--79
3. Remove the cover: See Figure 4--48, page 4--78.
a. Remove the six Phillips screws that secure the cover to the chassis.
b.
Slide the chassis out toward the rear of the cover.
4.
Remove the lock-down shaft and bracket: See Figure 4--48, page 4--78.
a. Remove the two Phillips screws that secure the bracket to its mount.
Remove it.
b. Lift out the lock-down shaft.
5.
Reinstallation: Perform steps 2 through 4 in reverse to reassemble the
module.
a. If installing a replacement the front panel, do the following steps before
performing step 2:
1
Remove the backing from the front panel label.
1
Align the holes and attach to the front panel.
b. If installing a replacement cover, do the following steps before perform-
ing step 3:
1
Remove the backing from the antistatic label.
1
Install the antistatic label to the replacement cover.