Tektronix DSA8200 Series, Service Manual

Page: 95 / 196

Removal and Installation Procedures
DSA8200 Digital Serial Analyzer and Modules Service Manual
4--37
Hard drive
Hard drive chassis bottom
Phillips screw (4)
Figure 4--21: Removing the hard disk drive from the cartridge (serial number
B030000 and above)
1. Locate module to be removed: Locate the CD-RW/DVD drive in the locator
diagram Internal Modules , Figure 4--8, page 4--20. Additional modules to be
removed:
1
Trim (all)
1
Bottom cover
1
Left and Right covers
2.
Orient the instrument: Set the instrument so its bottom is down on the work
surface and its front panel is facing you.
3. Remove the CD-RW/DVD drive trim. See Figure 4--22, page 4--38 for serial
numbered instruments B029999 and below. See Figure 4--23, page 4--39 for
serial numbered instruments B030000 and above. Remove the two Phillips
screws that hold the trim to the mounting frame and remove the trim.
4. Remove the CD-RW/DVD drive. See Figure 4--22, page 4--38.
a. Place one thumb on each side of the front of the CD-RW/DVD drive and
your forefingers on the back of the drive.
CD-RW/DVD Drive