Removal and Installation Procedures
4-16
AWG7000 Series Service Manual
Figure 4-6: Fan tray unit removal
Front-Panel Unit
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal.
To remove the front-panel unit, refer to Figure 4-7 and follow these steps:
1.
Remove the handle unit, snaps, cosmetic covers, front-trim unit, and EMI
covers.
2.
Orient the instrument so that the rear is on the work surface.
3.
Remove the seven screws securing the front-panel bracket to the chassis.
4.
Grasp the front-panel assembly and pull it forward.
5.
Disconnect the cable from J100 on the LCDA board.
6.
Disconnect the cable from J300 on the LCDA board.
7.
Disconnect the cable from J100 on the Front Switch board.
Installation.
To install, reverse this procedure.
Front-Panel Assembly
You need a a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal.
To remove the front-panel assembly, refer to Figure 4-7 and follow these
steps:
Fan bracket
Summary of Contents for AWG7000 Series
