Tektronix AWG7000 Series, Service Manual

Page: 59 / 140

AWG7000 Series Service Manual
4-7
Removal and Installation Procedures
This section contains procedures for removal and installation of all mechanical and
electrical modules.
Preparation
This section contains the following items:
„
This preparatory information that you need to properly do the following
procedures.
„
List of tools required to remove and disassemble all modules.
„
Procedures for removal and reinstallation of the modules.
Adjustment after repair
After the removal and replacement of a module due to electrical failure, perform
the adjustment procedures. Refer to the
Adjustment Procedures section.
List of Modules The Replaceable Parts section provides a list of all replaceable modules. Any
electrical or mechanical module, assembly, or part listed in the parts list is referred
to as a module.
WARNING.
Only qualified personnel should perform service procedures.
Before performing this or any other procedure in this manual, read the General
Safety Summary and Service Safety Summary found at the beginning of this
manual.
To prevent damage to the instrument components, read Preventing ESD in this
section.
Before doing any procedure in this section, disconnect the power cord from the line
voltage source.
NOTE.
Read Equipment Required for a list of the tools needed to remove and install
modules in this instrument. See Table 4-3, on page 4-10. Read the cleaning
procedure before disassembling the instrument for cleaning.