Tektronix AWG7000 Series, Service Manual

Page: 62 / 140

Removal and Installation Procedures
4-10
AWG7000 Series Service Manual
Required Equipment
Most modules in the instrument can be removed with a screwdriver handle
mounted with a size T-15, Torx screwdriver tip. All equipment required to remove
and reinstall the modules is listed in Table 4-3.
Disconnecting and Connecting the SMP cable
When you disconnect or connect the SMP cable, use the pliers specified in
Table 4-3 and keep the connector vertical. If excessive sideways force is applied,
the connector is damaged.
Figure 4-3: Disconnecting and connecting the SMP cable
Table 4-3: Tools required for module removal and reinstall
Item # Name Description General tool #
1. Screwdriver handle Accepts Torx-driver bits 620-440
2. T-15 Torx tip Torx-driver bit for T-15 size screw
heads 640-247
3. T-10 Torx tip Torx-driver bit for T-10 size screw
heads
4. T-20 Torx tip Torx-driver bit for T-20 size screw
heads
5. #1 Phillips screwdriver Screwdriver for removing #1 size
Phillips screws Standard tool
6. #2 Phillips screwdriver Screwdriver for removing #2 size
Phillips screws Standard tool
7. 3/16 inch open-end wrench Used to remove nut posts Standard tool
8. Pliers Pliers modified for use in SMP cable
insertion/extraction 003-1895-00
9. 5/16 inch torque wrench (8.0
in-lbs) Used to remove SMA cables
10. Angle-Tip Tweezers Used to remove the front-panel knob Standard tool
Connect and disconnect straight
Do not move from side to side.