Removal and Installation Procedures
4-20
AWG7000 Series Service Manual
DVD-ROM Board
You need a #1 Phillips screwdriver (item 5).
Removal.
To remove the DVD-ROM board, refer to Figure 4-8 on page 4-19 and
follow these steps:
1.
Remove the handle unit, snaps, cosmetic cover, front-trim unit, EMI covers,
hard disk assembly, and drive-bay module.
2.
Remove the two screws securing the DVD-ROM board to the DVD-ROM
drive.
3.
Disconnect the cable from J1 on the DVD-ROM board.
4.
Disconnect the interface cable on the DVD-ROM board.
5.
Lift the board away from the DVD-ROM drive.
Installation.
To install, reverse this procedure.
Multi-Input/Output Board
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal.
To remove the Multi-Input/output board, refer to Figure 4-9 and follow
these steps:
1.
Remove the handle unit, snaps, cosmetic covers, front-trim unit, and EMI
covers.
2.
Orient the instrument so that the bottom is on the work surface and the rear is
facing you.
3.
Disconnect the cables from J360, J670, J680, and J681 on the
Multi-Input/Output board.
4.
Remove the six screws securing the Multi-Input/Output board to the chassis.
5.
Carefully pull up on the board to loosen it from the Processor board.
6.
Lift the board away from the chassis.
Installation.
To install, reverse this procedure.
Summary of Contents for AWG7000 Series
