Tektronix 422, Instruction Manual

Page: 38 / 213

Operating I nstructions—Type 422 AC-DC
-
N .
^
•
V
Line
F r a n u o n r v
/
S
S
^
Des
Sig
*N
ired
nal
s
s
/
s
:
------
s,
(A ) Channel 1 signal. (B) Channel 2 signal. (C) Resultant display.
Fig. 2-21. Using the ALG ADD feature for common-mode rejection: (A) Channel 2 signal contains desired information along with
line-frequency component, (B) Channel 2 signal contains line-frequency only, (C) resultant CRT display using common mode rejection.
8. The signal which remains should be only the desired
portion of the Channel 1 signal. The undesired signal is
cancelled out.
EXAMPLE. An example o f this mode o f operation is
shown in Fig. 2-21. The signal applied to Channel 1
contains
unwanted line-frequency components (Fig.
2-21 A). A corresponding line-frequency signal is connected
to Channel 2 (Fig. 2-21B). Fig. 2-21C shows the desired
portion of the signal as displayed when common-mode
rejection is used.
5. Set the TRIGGERING Source switch to CH 1 & 2.
6. Set the vertical Mode switch to ALG ADD. Pull the
INVERT switch so the common-mode signals are of oppo­
site polarity.
7. Adjust the Channel 2 VO LTS/DIV switch and V A R ­
IABLE V O LTS/D IV control fo r maximum cancellation of
the common-mode signal.
j
i
2-28