DynaJet® IC7140
98-05347-EN-R1_A4LT-DynaJetIC7140-UM.docx
1
2
3
4
5
6
7
8
9
A
31
Figure 5-9:
Nozzles per Section
Use these softkeys to assist in establishing settings:
Equal Number of Nozzles – Press to set all sections to
have the same number of nozzles as the value set for
Section 1.
Symmetric Sections – Press to establish if sections are
paired and therefore share the same nozzles per section.
Sections on right will be mirrored with sections on left.
The total number of nozzles is what is displayed on the Operation
Screen. Displaying of individual dynamic boxes for each nozzle will be
limited by the size of the UT screen. Once the maximum number of
nozzles has been met, the spaces between nozzles will disappear, but
individual nozzle status will still be shown as on (blue) or off (grey).
Figure 5-10:
Visual Under Maximum Individual Nozzles
Figure 5-11:
Visual Over Maximum Individual Nozzles
Gain Preset Setup
Gain Preset Setup establishes up to five (5) presets of
proportional/derivative gain combinations.
WARNING! With each nozzle change or when nozzles are replaced, a
system calibration (steps NO. 5 CALIBRATE THE RATE
CONTROLLER REGULATION and NO. 6 CALIBRATE THE
DYNAJET IC7140 SYSTEM in the "INITIAL START-UP &
CALIBRATIONS" chapter) must be completed before attempted
operation. These configurations may affect Gain settings. Failure
to properly configure and calibrate the system will result in sub-
standard performance.
1.
From the Main setup screen, select
Gain Preset Setup
.
2.
Select a Gain Preset Number.
3.
Set the Derivative Gain Value.
4.
Set the Proportional Gain value.
To select the active gain preset combination, go to the Machine Setup
menu.
Figure 5-12:
Gain Preset Setup
2
3
4
1
Summary of Contents for DYNAJET IC7 140
Page 1: ...DYNAJET IC7140 INSTALLATION SETUP USER MANUAL 98 05347 R1...
Page 73: ......
