DynaJet® IC7140
www.teejet.com
18
1
2
3
4
5
6
7
8
9
A
No Rate Controller Communications
Machine Setup is found in the Main Menu screen. When initially
setting up the system, setting parameters for Number of Sections,
Nozzles per Section, and Pressure Sensor Max is strongly suggested.
Other machine settings and user parameters can be adjusted as
needed after calibrating the system.
NOTE: Gain settings will be calibrated in following sections.
1.
From the Home screen, press the MAIN SETUP KEY.
2.
Select
Machine Setup
.
3.
Establish:
►
Number of Sections – Set the number of boom sections.
►
Nozzles per Section – Press the ARROW BUTTON to go to
the Nozzles per Section Screen. Enter a value for each
section.
►
Pressure Sensor Max – Enter the maximum pressure value
as indicated on the pressure sensor label.
Figure 3-4:
Machine Setup
Setup and Select Nozzle
Preset nozzle favourites allows saving of up to five (5) nozzles for
quick recall. Use this to quickly access the most frequently used spray
nozzles including these being used for initial startup calibrating.
When communicating with a rate controller, be sure that both the rate
controller and the DynaJet are set to the same nozzle.
Establish Nozzle Favourite(s)
1.
From the Home screen, press NOZZLE FAVOURITES KEY.
2.
Select ADD NOZZLE BUTTON. Nozzle selection will be
established in the associated favourites location.
3.
On the Nozzle Selection screen,
◄
Select a nozzle series.
◄
Select the nozzle capacity.
4.
Press the PREVIOUS SCREEN KEY to complete the selection
and return to the Nozzle Favourites screen.
5.
Repeat steps 2-3 to establish additional nozzle favourites.
Select Current Nozzle
If more than one favourite is established:
1.
Select the nozzle to be used during the System Functional Test.
Figure 3-5:
Nozzle Selection
Summary of Contents for DYNAJET IC7 140
Page 1: ...DYNAJET IC7140 INSTALLATION SETUP USER MANUAL 98 05347 R1...
Page 73: ......
