DynaJet® IC7140
98-05347-EN-R1_A4LT-DynaJetIC7140-UM.docx
19
1
2
3
4
5
6
7
8
9
A
NO. 3 GET TO KNOW THE CONTROL MODES
To begin calibrating the system, an operation mode needs to be established. There are three types of Operation Modes:
Manual Mode –
Select the intended nozzle and the target PWM Duty Cycle Percentage. The system will calculate and display the droplet sizes
for the nozzle selected. DynaJet IC7140 will control to the target Duty Cycle Percentage.
Droplet Mode –
Select the intended nozzle and the target droplet size range. The system will calculate and display the median boom pressure
required to meet this droplet size range for the nozzle selected. DynaJet IC7140 will control to maintain the target droplet size range.
NOTE: Droplet Mode may not be available with all system configurations.
Adjustable Droplet Mode –
Select the intended nozzle and the droplet size range with the option to adjust the target droplet size. The system
will calculate and display the droplet size for the nozzle selected at the target droplet size. DynaJet IC7140 will control to maintain the target
droplet size.
NOTE: Many factors including but not limited to application rate, material density, speed, nozzle model/size/spacing may limit the ability of
DynaJet IC7140 to meet the control target.
See the “OPERATION” chapter for more details on each mode.
To select an operation mode:
1.
From the Home screen, press the OPERATION KEY.
2.
Press the CURRENT OPERATION MODE INDICATOR & MODE CHANGE BUTTON on the Nozzle Pressure Gauge. Modes will toggle from
Manual Mode to Droplet Mode to Adjustable Droplet Mode.
Figure 3-6:
Operation Mode from Home Screen
Summary of Contents for DYNAJET IC7 140
Page 1: ...DYNAJET IC7140 INSTALLATION SETUP USER MANUAL 98 05347 R1...
Page 73: ......
