DNAM Stereo output cable (from Stereo Speaker Kit)
Stereo Speaker Kit
The Stereo Speaker Kit applies for systems with DNAM and a stereo
SPDIF output:
•
TANDBERG 8000
MXP
(standard)
•
TANDBERG 6000
MXP
Profile
•
TANDBERG Maestro
MXP
NOTE!
If the stereo speakers setting is enabled in the menu without
having any stereo speakers connected to the Digital NAM, or having
other speakers than the TANDBERG stereo speakers, it may cause the
acoustic echo-canceller to malfunction.
Stereo Speaker Kit
The Stereo Speaker Kit provides a pair of floor-standing loudspeakers
in addition to the built-in DNAM.Using these speakers will enable stereo
functionality in your system and thereby enhance the sound experience.
To experience stereo sound, the stereo speakers have to be connected to
the Digital Natural Audio Module (DNAM) as well as confirming this under
Stereo Settings in the main audio menu.
The stereo sound source may either be located at the far end, or locally
as a sound source (CD, DVD) connected to the codec audio AUX/VCR
inputs.
Control Panel Settings
If using a local stereo sound source, you also have to enable Stereo I/O
mode (On) in the same audio menu, to be able to receive stereo sound
on your system, and to send stereo signals to the far end. See the stereo
audio settings for more information.
Check also that the full-range frequency audio coding AAC-LD is
enabled. Go to the Call Quality menu and see that AAC-LD is checked,
and that AAC-LD 128 threshold is the same or lower than the call rate
you are planning to use. See the Call Quality menu, Audio Algorithm and
AAC-LD 128kbps for more information.
Installation
An installation sheet is enclosed in the Stereo Loudspeaker Kit,
which also describes recommended physical speaker placement.
IMPORTANT!
Make sure the complete video communication system is
powered down before connecting the Stereo Speaker Kit.
Stereo Speaker Kit specification
•
2-way Stereo Speaker system (dual speakers in low- and midrange)
•
Passive Crossover Filtering.
•
Frequency range 50Hz - 20kHz
•
2 x 130mm low- and midrange loudspeakers, 8 ohms nominal, high
quality.
•
1 x 25mm dome tweeter, 6 ohms nominal, high quality
•
Long time max power 90 Watt on all loudspeakers
•
Enclosed aluminum speaker cabinet
D14033.06—AUGUST 2010
313
MXP
Administrator Guide
Contents
Introduction
Getting started
The menu structure
The settings library
Using the system
Physical interfaces
Peripheral equipment
Contact us
Appendices
Peripheral equipment
