MENU ADDRESS
SETTINGS DESCRIPTION
INFORMATION
PRODUCT
Control Panel >
General >
Screen Settings >
VIDEO OUT
VGA OUT QUALITY DUAL
AUTO:
The VGA output format will be optimized depending on video source format, refresh rate and EDID
information available. Supported formats are:
SVGA
(800x600) 75 Hz
XGA
(1024x768) 60Hz /75 Hz
WXGA
(1280x768) 60 Hz
W720P
SVGA 800X600:
The VGA output format is forced to SVGA format (800x600) 75 Hz
XGA 1024X768:
The VGA output format is forced to XGA format (1024x768) 60 Hz
W720P:
The VGA output format is forced to w720p
The supported range of VGA formats will be optimized for the
VGA display monitor based on the source image.
VGA Out Quality Dual enables the user to change the preferred
format for the DVI/VGA output. It is recommended to keep this
setting in Auto unless your screen doesn’t support some of the
XGA or SVGA formats the system is using. Note that the VGA
Out port supports VESA Power Management.
8000
6000
Maestro
1700
Control Panel >
General >
SOFTWARE OPTIONS
OPTIONS INSTALLED
This section shows you which options are currently installed on your system. To activate a new option, you
must have a valid option key.
NOTE:
After entering the new option key you must restart the system to activate
the new option.
The following options are available:
•
No option
•
Presenter
•
Mul Presenter
•
Bandwidth options
MultiSite:
The TANDBERG MultiSite feature (using an
embedded MCU) enables you to setup multipoint calls with
three or more participants - by video and/or telephone.
Presenter:
The TANDBERG Natural Presenter Package
(NPP) allows you to bring your presentations to life using
PCs, document cameras and video (also mentioned as dual
stream). Bandwidth decides the quality of the video call. High
bandwidth gives high quality.
All MXP
systems
Control Panel >
General >
SOFTWARE OPTIONS
SERIAL NO
Shows the serial number of the video system.
The Serial Number format is xx.xxxxx or xxAxxxxx.
The Serial Number is also found on a sticker on the system. It
is essential for identifying the system when it comes to service
contracts or other support activities.
All MXP
systems
Control Panel >
General >
SOFTWARE OPTIONS
CURRENT OPTION KEY
Shows the current option key.
All MXP
systems
Control Panel >
General >
SOFTWARE OPTIONS
CURRENT BANDWIDTH KEY
Shows the current bandwidth key.
All MXP
systems
Control Panel >
General >
SOFTWARE OPTIONS
NEW OPTION KEY
To activate a new option, enter the new option key and restart the system.
If the key is invalid, the original key will be used.
Please contact your TANDBERG representative to order a new
option.
All MXP
systems
D14033.06—AUGUST 2010
171
MXP
Administrator Guide
Contents
Introduction
Getting started
The menu structure
The settings library
Using the system
Physical interfaces
Peripheral equipment
Contact us
Appendices
The settings library
