TANDBERG MXP F8 -, Administrator'S Manual

Page: 213 / 375

MENU ADDRESS SETTINGS DESCRIPTION INFORMATION PRODUCT
Control Panel >
Network >
LAN Settings >
H.323 Settings >
CALL MANAGER SETTINGS
CALL MANAGER EXTENSION
If Call Manager was enabled in the H.323 Call Setup , you may enter a call manager extention in this field.
Example: 524036
Control Panel >
Network >
LAN Settings >
H.323 Settings >
CALL MANAGER SETTINGS
CALL MANAGER IP
If Call Manager was enabled in the H.323 Call Setup , enter the IP Address to the Call Manager in this field.
Example: 10.0.0.30
All MXP
systems
Control Panel >
Network >
LAN Settings >
H.323 Settings >
ADVANCED H.323 SETTINGS
NAT
NAT support in the videoconferencing system enables proper exchange of audio/video data when connected to
an external videoconferencing system (when the IP traffic goes through a NAT router).
OFF: The system will signal the real IP Address.
ON:
The system will signal the configured “NAT Address” in place of its own IP-address within Q.931 and
H.245. When NAT is On, the NAT Server Address will be shown in the startup-menu as:
My IP Address:
10.0.2.1
AUTO: The system will try to determine if the “NAT Address” or the real IP-address should be used within signaling. This is
done to make it possible to place calls to endpoints on the LAN as well as endpoints on the WAN.
NOTE!
The Advanced H.323 Settings only have effect if they are
supported by your IP infrastructure.
All MXP
systems
Control Panel >
Network >
LAN Settings >
H.323 Settings >
ADVANCED H.323 SETTINGS
NAT ADDRESS
This must be the external/global IP-address to the router with NAT support. Packets sent to the router will
then be routed to the system. In the router, the following ports must be routed to the system’s IP-address:
•
Port 1720
•
Port 5555-5574
•
Port 2326-2485
NOTE! The Advanced H.323 Settings only have effect if they are
supported by your IP infrastructure.
All MXP
systems
Control Panel >
Network >
LAN Settings >
H.323 Settings >
ADVANCED H.323 SETTINGS
RSVP
AUTO: Resource Reservation Protocol enables the system to request the optimum amount of bandwidth for
the duration of an IP video conference.
OFF: Resource Reservation Protocol is switched Off.
NOTE!
The Advanced H.323 Settings only have effect if they are
supported by your IP infrastructure.
All MXP
systems
D14033.06—AUGUST 2010
213
MXP
Administrator Guide
Contents Introduction Getting started The menu structure The settings library Using the system Physical interfaces Peripheral equipment Contact us Appendices
The settings library