MENU ADDRESS
SETTINGS DESCRIPTION
INFORMATION
PRODUCT
Control Panel >
Network >
ISDN >
or
ISDN, External, Leased
E1/T1 >
ISDN-BRI SETTINGS
ISDN SWITCH TYPE
Select the type of ISDN network connected to your unit.
Note that 1TR6 should only be used if you are operating the system behind a PABX.
All MXP
systems
with ISDN-
BRI
Control Panel >
Network >
ISDN >
or
ISDN, External, Leased
E1/T1 >
ISDN-BRI SETTINGS
AUTO BRI CONFIG
The Auto-BRI Config setting is only applicable after the ISDN Switch Type is set to National ISDN and the
change has been saved.
ON:
When set to On, the system retrieves SPID (Service Profile Identifier) values automatically from the
network. Not supported by all National ISDN networks.
OFF:
When set to Off the SPID is to be set manually.
All MXP
systems
with ISDN-
BRI
Control Panel >
Network >
ISDN >
or
ISDN, External, Leased E1/T1 >
ISDN-BRI Settings
LINE 1-6 SETUP
LINE ENABLE
Select Line Setup for the ISDN-BRI Line you want to configure. Enable the active lines and disable the
unused lines. Note that Line 1 should always be enabled.
ON:
When set to On the ISDN-BRI line is enabled. Line 1 should always be enabled.
OFF:
When set to Off the ISDN-BRI line is disabled. Unused ISDN-BRI lines must be disabled.
Some software versions do not support 6 ISDN-BRI lines. If so,
some of the Line Setup entries may be grayed out.
All MXP
systems
with ISDN-
BRI
Control Panel >
Network >
ISDN >
or
ISDN, External, Leased E1/T1 >
ISDN-BRI Settings
LINE 1-6 SETUP
NUMBER 1, NUMBER 2
Select Line # Setup for the ISDN-BRI Line you want to configure. Enable the active lines and disable the
unused lines.
Enter the numbers associated with your ISDN-BRI lines.
Most BRI’s with SPID’s are area code and number at the end, like so:
70312345670101
All MXP
systems
with ISDN-
BRI
Control Panel >
Network >
ISDN >
or
ISDN, External, Leased E1/T1 >
ISDN-BRI Settings
LINE 1-6 SETUP
SPID1, SPID2
If your ISDN-BRI Switch Type is
NATIONAL ISDN
or
AT&T CUSTOM ISDN
, they might require SPID (Service
Profile IDentifier) numbers associated with your ISDN-BRI numbers.
If you have received two different SPID numbers for each ISDN-BRI line from your network provider, you must
enter both numbers.
All MXP
systems
with ISDN-
BRI
D14033.06—AUGUST 2010
202
MXP
Administrator Guide
Contents
Introduction
Getting started
The menu structure
The settings library
Using the system
Physical interfaces
Peripheral equipment
Contact us
Appendices
The settings library
