1D-28 Engine Mechanical: For M16A Engine with VVT
4) Loosen camshaft housing bolts in such order as
indicated in the figure and remove them.
5) Remove camshaft housings.
6) Remove intake and exhaust camshafts.
7) Remove camshaft bearing (1).
8) Remove tappets (2) with shims (1).
Installation
1) Install tappets and shims to cylinder head.
Apply engine oil around tappet and then install it to
cylinder head.
NOTE
When installing shim, make sure to direct
shim No. side toward tappet.
2) Install camshaft bearing (1) to cylinder head.
CAUTION
!
Do not apply engine oil to camshaft bearing
back.
Only a upper half bearing of intake camshaft
bearing No.1 has some holes. Other
bearings.
3) Install intake camshaft (1) and exhaust camshaft (2).
Align knock pin (3) and match mark (4) with notches
(5) as shown in the figure.
NOTE
Before installing camshafts, turn crankshaft
until key position faces upward.
Refer to “Timing Chain and Chain Tensioner
Removal and Installation: For M16A Engine
with VVT”.
“12” “13” “20” “21” “16” “17” “8” “9”
“2”
“5”
“3”
“4”
“1”
“10” “11” “18” “19” “14” “15” “6” “7”
I3RM0A140031-01
1
I3RH0B140039-01
I2RH0B140074-01
I2RH0B140075-01
1
I3RH0B140039-01
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir
