Engine Mechanical: For M16A Engine with VVT 1D-55
7) If necessary, press-fit rear oil seal (1) to oil seal
housing (2) by using special tool as shown in the
figure.
Special tool
(A): 09911–97821
Crank rear oil seal installing position
(dimension)
“a”: 2 mm (0.08 in.)
8) Apply sealant to mating surface of rear oil seal
housing (1).
“A”: Water tight sealant 99000–31250 (SUZUKI
Bond No.1207F)
Sealant amount for rear oil seal housing
Width: “a”: 3 mm (0.12 in.)
Height “b”: 2 mm (0.08 in.)
9) Install rear oil seal housing (1) and tighten bolts to
specified torque by using special tool.
Special tool
(A): 09911–97720
Tightening torque
Rear oil seal housing bolt: 11 N·m (1.1 kgf-m, 8.0
lb-ft)
10) Install flywheel (for M/T).
Using special tool, lock flywheel, and tighten
flywheel bolts to specified torque.
NOTE
Use new flywheel bolts.
Special tool
(A): 09924–17810
Tightening torque
Flywheel bolt (a): 70 N·m (7.0 kgf-m, 51.0 lb-ft)
11) Install piston and connecting rod referring to
“Pistons, Piston Rings, Connecting Rods and
Cylinders Removal and Installation: For M16A
Engine with VVT”.
12) Install engine assembly to vehicle referring to
“Engine Assembly Removal and Installation: For
M16A Engine with VVT”.
I2RH0B140131-01
I5JB0A141028-01
I4RS0A140018-01
A: Crankshaft side
I4RS0A140019-01
I2RH0B140134-01
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir
