1D-22 Engine Mechanical: For M16A Engine with VVT
Installation
1) Install new O-ring (4) to oil control valve.
2) Install oil control valve to timing chain cover.
Tighten nuts to specification.
Tightening torque
Oil control valve mounting nut (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
3) Install oil gallery pipe No.1 with new copper washers
(5) to timing chain cover.
Tighten bolts to specification.
Tightening torque
Oil gallery pipe No.1 bolt (b): 30 N·m (3.0 kgf-m,
21.5 lb-ft)
4) Install P/S pump bracket.
5) Install P/S pump to its bracket referring to “P/S Pump
Removal and Installation for M16 Engine Model: in
Section 6C”.
6) Install P/S pump and A/C compressor drive belt
referring to “P/S Pump and A/C Compressor (If
Equipped) Drive Belt Removal and Installation for
M16 Engine Model: in Section 6C”.
7) Adjust P/S pump and A/C compressor drive belt
tension referring to “P/S Pump and A/C Compressor
(If Equipped) Drive Belt Inspection and Adjustment
for M16 Engine Model: in Section 6C”.
8) Refill engine with engine oil referring to “Engine Oil
and Filter Change: in Section 0B”.
Oil Control Valve Inspection
S5JB0A1416044
Oil Control Valve
1) Inspect strainer (1) and mating surface (2) of oil
control valve for clog or damage. Clean oil control
valve if clog or foreign matter is present on strainer
or mating surface of oil control valve.
Replace oil control valve if its mating surface is
damaged.
2) Check resistance between terminals of oil control
valve.
Oil control valve resistance
6.7 – 7.7
Ω
(at 20
°
C (68
°
F))
Oil Gallery Pipe
Inspect oil gallery pipe No.1 (1), No.2 (2) and No.3 (3).
Replace if crack, deformation or clog exists.
1
5
(b)
3
(a)
2
4
5
I3RM0A140027-01
1
2
I3RM0A140028-01
1
3
2
I3RH0B140030-01
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir
