1D-16 Engine Mechanical: For M16A Engine with VVT
17) With hose connected, detach A/C compressor from
its bracket (if equipped) referring to “Compressor
Assembly Removal and Installation for M16 Engine
Model: in Section 7B”.
CAUTION
!
Suspend removed A/C compressor at a place
where no damage will be caused during
removal and installation of engine assembly.
18) Support front suspension frame and engine rear
mounting member using jack (2).
19) Carry out Step 1) to 12) of “Removal” under “Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B” in order to
lower engine with front suspension frame.
20) Remove front suspension frame mounting bolt (1).
21) Remove engine rear mounting member bolt (1).
22) Before lowering engine with transmission and front
suspension frame from engine compartment,
recheck to make sure all hoses, electric wires and
cables are disconnected from engine.
23) Lower engine with transmission and front
suspension frame from engine compartment.
CAUTION
!
Before lowering engine, in order to avoid
damage to A/C compressor and P/S pump,
make clearance by rising them.
24) Disconnect transmission from engine referring to
“Manual Transmission Assembly Dismounting and
Remounting: in Section 5B”, if necessary.
25) Remove engine with engine front mounting bracket
(1) from engine front mounting (2), if necessary.
26) Remove clutch cover and clutch disc referring to
“Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C”, if necessary.
Installation
1) Install clutch cover and clutch disc referring to
“Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C”, if necessary.
2) Install engine with engine front mounting bracket to
engine front mounting.
For tightening torque, refer to “Engine Mountings
Components: For M16A Engine with VVT”, if
necessary.
3) Connect transmission to engine referring to “Manual
Transmission Assembly Dismounting and
Remounting: in Section 5B”, if necessary.
4) Lift engine with transmission and front suspension
frame into engine compartment with jack.
CAUTION
!
Before lifting engine, in order to avoid
damage to A/C compressor and P/S pump,
make clearance by rising them.
5) Tighten engine rear mounting member bolt referring
to “Engine Mountings Components: For M16A
Engine with VVT”.
6) Carry out Step 5) to 19) of “Installation” under “Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B” in order to
lift engine with front suspension frame.
1
2
I5JB0A141017-02
I5JB0A141018-02
I5JB0A141019-01
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir
