1C-5 Engine Electrical Devices:
Accelerator Pedal Position (APP) Sensor
Assembly On-Vehicle Inspection
S5JB0A1306024
1) Check that accelerator pedal position (APP) sensor
assembly has been mounted to vehicle body
properly (no pinched floor carpet, etc).
If mounting is not properly, reinstall accelerator pedal
position (APP) sensor assembly properly referring to
“Accelerator Pedal Position (APP) Sensor Assembly
Removal and Installation: ”.
2) Connect scan tool to DLC with ignition switch turned
OFF.
3) Turn ON ignition switch and select “Data List” mode
on scan tool.
4) Check that accelerator pedal position sensor voltage
varies as the following graph.
If sensor voltage is out of specified value or does not
vary linearly as the following graph, check
accelerator pedal position (APP) sensor assembly
referring to “Accelerator Pedal Position (APP)
Sensor Assembly Inspection: ”.
Accelerator Pedal Position (APP) Sensor
Assembly Removal and Installation
S5JB0A1306027
CAUTION
!
• Do not expose accelerator pedal position
(APP) sensor assembly to excessive shock
like a dropping it. If accelerator pedal
position (APP) sensor assembly has been
exposed to excessive shock, it should be
replaced.
• Be careful not to expose sensor section of
accelerator pedal position (APP) sensor
assembly to water.
NOTE
After replacing accelerator pedal position
(APP) sensor assembly, perform calibration
of throttle valve referring to “Electric Throttle
Body System Calibration: ”.
Removal
1) Disconnect negative cable at battery.
2) Disconnect connector from accelerator pedal
position (APP) sensor assembly.
3) Remove accelerator pedal position (APP) sensor
assembly from its bracket.
Installation
Reverse removal procedure for installation noting the
following.
• Tighten accelerator pedal position (APP) sensor
assembly upper nut (1) first and then lower nuts (2) to
specified torque.
Tightening torque
Accelerator pedal position (APP) sensor assembly
nut (a): 6.0 N·m (0.6 kgf-m, 4.5 lb-ft)
• If APP sensor assembly bracket is removed, tighten
its mounting nuts to specified torque
Tightening torque
APP sensor assembly bracket nut: 6.0 N·m (0.6
kgf-m, 4.3 lb-ft)
• Connect connector to accelerator pedal position
(APP) sensor assembly securely.
[A]: Accelerator pedal position (APP) sensor (main) voltage
[B]: Accelerator pedal position (APP) sensor (sub) voltage
[C]: Sensor output voltage
[D]: Idle position of accelerator pedal
[E]: Full depressed position of accelerator pedal
[F]: Pedal stroke
[C]
[B]
[D]
[F]
[E]
[A]
1.74 - 2.17 V
0.65 - 0.82 V
3.50 - 4.27 V
0.30 - 0.44 V
I5JB0A130018-05
1, (a)
2, (a)
I5JB0A130036-01
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir
