SunStar SSP-WE/3.5, Instruction Manual

Page: 107 / 158

107
Embroidery Conversion Function
It provides the function to convert embroidery design file *.sst of SunStar and
*.dst of TAJIMA into pattern file. You can convert and display or save embroidery
design only up to 30,000 stitches in SSP-WE/1.0 at present. But, please
remember that you can use embroidery design only up to 20,000 stitches in
pattern machine.
Embroidery design conversion function is as follows:
①
Select
“
Embroidery Call Function
”
from
“
Image
Punching
”
menu item. Upon selecting it,
“
Embroidery File Call Dialogue
”
box appears
as shown below.
②
Convert embroidery file by selecting file name and embroidery file type to create in
“
Embroidery File Call Dialogue
”
box and pressing the opening button. Description by
each item is as follows:
③
Open Dialogue box shall appear that you can select embroidery file to call for con-
version. Select embroidery file to convert and then press
“
Open
”
button. Open
dialogue box shall disappear again and
“
Embroidery File Call Dialogue
”
shall
appear.
Embroidery File Type : It is the item to select embroidery file type to convert at
present. We selected TAJIMA file in the figure above.
OK Button : If you press
“
OK
”
button, embroidery file is converted into pattern file.
After setting up the items above, select the button
“
Embroidery File Open
”
.
Input File Name : It is the item to input the name
that embroidery file is converted and saved into
pattern file.
Embroidery File Open : It is the button to call
embroidery file to convert.
Jump Stitch Length: The default value of this
field is set to
“
0
”
. If this value is increased,
jump converts to normal stitch and is
created with default value
“
0
”
during
embroidery file conversion. No problems
occur for normal embroidery files, but for
those with width over 12.7mm between
stitch and stitch, increase the setup value
prior to conversion.