SUN EAST PEAK-350
电脑波峰焊用户手册
60 -74
(1)
Please be sure that the power supply is off.
(2)
Put on guard-glove and open the safe cover beside the solder pot by hexagon wrench 4 and
take off the adiabatic cotton.
(3)
Find out the worn heat pipes by multimeter and disconnect its wires by open-end wrench.
(4)
Take out of the worn heat pipe and replace them with new ones.
Note
Let the liquid solder out and take off the solder pot if it is not easy to take off the heat pipe.
Install the solder pot after replacing the heat pipe with new ones.
(5)
Connect the new heat pipe with the wires and install the safe cover and adiabatic cotton.
Close the side covers and fix it.
(6)
Switch on the power supply and re-run the machine.
Item
Solder Pot
Maintenance
Replace the solder.
Tools
Circular ended wrench, screw drive and brush
Maintenance Steps
(1)
Turn on the heater of solder pot and melt all solder in it, then turn off the heater of solder
pot and switch off the power supply.
(2)
Open the outlet and let the solder out. Be careful of the hot solder.
(3)
Tighten the nozzle to avoid solder leaking before the solder is solidified. Clean the leftover
solder on the nozzle.
(4)
Drive the outlet screw by circular ended wrench and embrocate it with engine oil by brush.
(5)
Tighten the outlet screw with engine oil by circular ended wrench and supplement the
solder pot with solder.
(6)
Switch on the power supply and turn on the heater of solder pot, and then melt the solder by
heating.
(7)
Write down the date of replacing the solder.
Note:
The solder dross can be re-used after filtering the sundries, oxide and residue etc.
Item
Solder Pot
Maintenance
Clean the oxide.
Tool
Spoon
Maintenance Steps
