SUN EAST PEAK-350
电脑波峰焊用户手册
28 -74
Chapter IV Operation Regulation
Precautions:
1.
All safety devices should be OK before operation.
2.
Be sure that the machine will not hurt anybody before turning on the power supply.
3.
Check if any safety device is broken to ensure that the safety device will work in case the
machine is on run abnormally.
4.
The safety devices consist of stop button, power switch, machine covers etc.
5.
Press stop button if there appears any emergency, and the machine will stop running.
Reset stop button by turn it from left to right before the machine re-starts running.
6.
There are power switch and powerful control components in the control panel positioned
on the back of machine. The cover with warning label on the control panel can be
dismantled. Turn off the power switch if there is no necessity to use the machine for a
long time.
4.1 Theory of Operation
Work Flow:
PCB will go into the conveyor (07) from the buffer (02). The sprayer (03) will spray the flux
on the bottom of PCB and the PCB goes into the pre-heater (05). The solder pot (08) will solder the PCB and
the PCB will go into the cooler (09). At last, the PCB will output from the conveyor (07). The whole process
is under the control of control system and all parameters can be preset on the display (01).
4.2 Software Operation
4.2.1 Precautions before Trial Operation
