SUN EAST PEAK-350
电脑波峰焊用户手册
54 -74
(4)
Close the conveyor chain if the engine oil is embrocated evenly on all bearings and
tighten the screw by open-end wrench.
Note
1.
Do not let your hands reach the chain or let the sundries fall into the chain when the
conveyor system is on run, so as to avoid hurting the personnel or damaging the
machine.
2.
Do not adjust the width of lead rail when the conveyor system is on run.
3.
Press stop button to stop running of machine if there appears any emergency. Do not
switch on the machine if the problem has not been solved. Shake the PCB out by
hand if there is PCB on the conveyor chain.
Maintenance Steps
(1)
Please be sure that the power supply is off. Disassemble the chain cover from the lead
rail by open-end wrench 8 and rotate the conveyor axis by open-end wrench, and turn
the chain claspers to Part 2.
(2)
Disassemble the nut and gasket on the axis by open-end wrench 8, and unload the
block spring of chain by pincer, and then replace the chain fingers with new ones.
Item
Conveyor System
Maintenance
Replace the chain fingers and force limiter of conveyor chain with
new ones.
Tools
Open-end wrench 8 (m5), open-end wrench 16, pincer, limit wrench
and brush
Part 1
Part 2
