SUN EAST PEAK-350
电脑波峰焊用户手册
17 -74
3.1 Preparation before Installation
Installation Requirement
1.
Locate the machine on a flat floor, dry and ventilative.
2.
The operation temperature should be 5 ~ 40
℃
.
3.
It should apply to 3 phases, 5 wires, 380V and steady-going power supply under rated
currency.
4. It should apply to the industrial air supply of 5-7Bar.
Note: Adopt separation measurement if there is epicentre around the equipment in order not to effect its
normal using.
3.2 Installation
3.2.1 Disassembly
Take out the pieces from the wrapper according to the packing list of the equipment. If there is any
damage, being affected with damp or missing parts etc, please contact with our company to solve it in time.
3.2.2:
Warning of Wiring
1.
Switch off the power supply and air supply before the wiring work proceeds.
2.
Do not tear down the seal during wiring to avoid the sundries falling inside the industrial computer
and inverter etc while the seal should be torn down during operation to give out the heat after the
wiring work has been completed.
3.
Verifying if all electric terminals are loosened because of the unavoidable wobble and
shake during transportation. If yes, please tighten the loosened terminals.
4.
Do not take off any safety switch or cancel any safety function on machine at will.
5.
Do electrification test after wiring work has been completed. Turn off all switches on
soldering system firstly and be sure that the voltage and capacity of outer power supply
can meet the needs of this soldering system. Then do the performance test by turning off
the switch according to the principle from big to small.
6.
There are warning labels for the wiring and do not tear any warning label. There should
be warning signs on every part with danger, with electricity, high temperature, high
