Stratasys J720, User Manual, Page: 79 / 159

Stratasys J750/J735/J720 User Guide 4 Operating and Maintaining the Printer
DOC-08040 Rev. R 4-53
13. In the following screen, you can choose to either repeat the head alignment
procedure, continue to the Color Uniformity wizard, or close the wizard.
Figure 4-68 Repeat head alignment option
❒
If the most closely aligned vertical lines for a print head were at either
extreme, choose Repeat the test , then click Next .
The additional transparency test will show if the heads are now properly
aligned, and—if not—the wizard will allow you to “fine tune” the
alignment.
❒
For High Mix and High Speed modes, if the head alignment parameters
were updated, you should "fine tune" the print heads to ensure color
uniformity, especially along the model's X-walls. To do this, choose
Run
Color Uniformity Wizard and click Next . The Head Alignment Wizard
Completed screen appears. When you click Done , the Color Uniformity
wizard opens.
❒
If the vertical lines for the print heads were not aligned at either extreme,
or if you do not want to run the color uniformity wizard, choose End this
wizard , then click Next .