Stratasys J750/J735/J720 User Guide
4 Operating and Maintaining the Printer
DOC-08040 Rev. R
4-10
Resuming Production After Printing has Stopped
If the printing process is interrupted, the print manager stops sending slices to the
printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to
Standby
or
Idle
mode, you need to resume printing
from the print manager in GrabCAD Print.
After printing stops, the printer goes into
Standby mode
, when heating of the
print heads is reduced. About 10 hours later, the printer goes into
Idle
mode,
when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in
offline
mode, switch it to
online
mode by clicking the red
button at the bottom of the printer interface (see the figure on page 4-4).
The button changes from red to green.
2. If you don’t know why printing has stopped, make sure that the connection
between the printer and the server computer is active.
3. Open the
Schedule
screen of GrabCAD Print.
Figure 4-6 Opening the
Schedule
screen
4. Locate the stopped job.
Figure 4-7 Stopped job in the
Schedule
screen
5. Click on the job to display the Job Status details, and click the
Resume
icon
.
OR—
Right-click on the job to display the pop-up menu, and select
Resume job
.