Stratasys 180-00108 uPrint, User Manual, Page: 55 / 68

Stratasys Document Number 206465-0001
Troubleshooting and Maintenance 55
ii. Insert 1/8 T-handled hex driver (from Start-Up Kit) into the fixture hole.
iii. Ease pressure on the 7/64 T-handle driver to carefully return the leveraged idler wheel back
toward its original position - until the idler assembly is resting against the 1/8 T-handled hex
driver.
iv. Remove the 7/64 T-handled driver used to leverage the idler assembly.
v. Clean the area that is now accessible. Remove the 1/8 T-handle hex driver when complete.
6. Remove excess material from the top of the liquefier.
• Use needle nose pliers to carefully grip and remove excess material from the top of the liquefier.
7. Snip the material line from the cartridge close to the drive wheel.
8. Make sure that all loose material is removed from the affected extrusion inlet area.
9. Check for loose material in the other extrusion inlet area. Clean the area as necessary.
Cycling Power
To cycle power to the printer:
1. Turn the power switch to the OFF position. The display will show Shutting Down .
2. After the printer has cooled down enough to shut down, the display will go blank.
3. When the display is blank and the printer has shut down, turn the circuit breaker to the OFF position.
4. Once the circuit breaker has been turned to the OFF position, wait 30 seconds and turn the circuit
breaker back to the ON position.
5. Turn the power switch to the ON position. The printer display will show that it is starting up.
Once the display shows Idle or Ready to Print , you can send a file to the printer to be printed.