Stratasys 180-00108 uPrint, User Manual, Page: 31 / 68

Stratasys Document Number 206465-0001
Setup 31
Figure 21: Latching the Carrier
Adding material carriers to the single material bay
Once the carriers have been filled, you will need to add the carrier into the material bay.
An instructional video can be viewed at http://www.uPrintDimension.com
Adding material carriers to the material bay:
1. From the display panel press Material , the display will show Add/Remove.
2. Add the model and support carriers to the material bay by inserting the carriers into the material bays
and latching into place.
Loading material to the head for the single material bay
1. Once the material carriers have been added to the material bays, press Load... next, press Load
Both . The display will show Loading Model . After the model material has loaded to the head the
display will show Loading Support .
Note:
It can take up to 5 minutes for the printer to load the material to
the head.
2. When the printer has finished loading support material to the head, press Done... the display will show
Wait for Part or Ready to Build (if a part is in the queue) and will also show the amount of material
remaining in the model and support carriers.
Adding material carriers to the dual material bays
Once the carriers have been filled, you will need to add the carrier into the material bay.
An instructional video can be viewed at http://www.uPrintDimension.com
Adding material carriers to the material bays:
1. From the display panel press Material , the display will show Add/Remove.
2. Add the model material carriers to the M1 and M2 material bays by inserting the carriers into the mate-
rial bays and latching into place.
3. Add the support material carriers to the S1 and S2 material bays by inserting the carriers into the mate-
rial bays and latching into place.