Stratasys Document Number 206465-0001
Setup
21
Inserting a modeling base
The modeling base is the tray the printer uses to build the models on. You will need to use a new modeling
base for every build.
Inserting a modeling base:
1. Make sure the two retainers are turned down so they do not interfere with modeling base installation.
2. Set the modeling base on the Z platform aligning the tabs on the modeling base with the slots on the
metal tray. See
Figure 9.
Figure 9: Z Platform Slots
3. Slide the modeling base down and toward the back of the unit until its front edge (with the handle) is
flush with the front edge of the tray. See
Figure 10.
Figure 10: Slide modeling base in place
4. Secure the modeling base with the two retainers by turning them up. See
Figure 11
.
Figure 11: Turn retainers to lock modeling base in place.
Align tabs with slots
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide ...