Stratasys Document Number 206465-0001
Setup
30
Figure 18: Removing the material spool
3. Remove the material retaining band. Be sure to remove the entire retaining band. DO NOT remove the
material guide from the spool at this time.
4. Place the spool in to the carrier with the material guide facing up.
5. Remove the material guide from the spool holding location.
6. Carefully remove material from the spool detent. See
Figure 19
and
Figure 20
.
Figure 19: Place model material spool in to model material carrier
Figure 20: Place support material spool in to support material carrier
7. Place the model material guide into position see
Figure 19
for model and
Figure 20
for support.
Note:
Model and Support Carriers are different. The material guide
tubes install on the opposite side. See
Figure 19
and
Figure 20
.
8. Close the carrier with the material guide in place. Latch both buckles completely (the red tab must
snap in to place on each buckle).
See
Figure 21
.
Note:
Material must protrude at least 1mm (0.04 inch) but not more than
30mm (1.18 inch) from the end of the material guide.
Foil bag
Material spool
Retaining band
Material detent
Material guide
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide ...