Stratasys Document Number 206465-0001
Setup
19
Set up the Material Bay and Printer
Once the Printer and the Material Bay are unpacked, they will need to be aligned and stacked before
operation.
1. Place the Material Bay on a stable, flat surface where you will have your
uPrint
3D printer located.
2. The Material Bay has 4 holes for the feet and 2 holes for the alignment pins. See
Figure 7
. These must
be seated properly for mechanical stability.
3. Align the 4 feet and 2 two pins on the bottom of the printer with the holes on top of the Material Bay and
set in place.
See
Figure 7
.
Figure 7: System Stacked (Shown with optional Material Bay)
4. Open the printer door and remove the substrate and VCI emitter and discard. See
Figure 8.
5. Remove the shipping foam from the Z stage guide rods and recycle. See
Figure 8.
6. Remove the belt retaining clips and recycle. See
Figure 8.
LIFTING HAZARD
Use proper moving and lifting techniques when positioning the unit.
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide ...