Stratasys 180-00108 uPrint, User Manual, Page: 43 / 68

Stratasys Document Number 206465-0001
Operation 43
Dual material bay LED’s
When using the optional second material bay, the LED’s on the material bay will become active. The table
below will show the status indicated by the LED’s.
Replacing material spools
Removing a spool of material from the carrier:
1. Place the carrier on a flat stable surface.
2. Unlatch the carrier and open.
3. Remove the spool of material. Discard any pieces of material that may remain in the carrier.
4. Remove the material guide and recycle. See “Removing the EEproms from the material guides” on
page 67
5. Recycle the empty material spool. See “Recycling” on page 66
Installing a spool of material in to the carrier:
1. See “Installing a spool of material into the carrier:” on page 29 .
When the printer has finished loading material the display will show Idle or Ready to Build (if a part is in the
queue) and will also show the amount of material remaining in both model and support carriers.
Storing material
In the event you power down the printer for more than a few days, you will want to unload the material and
place it inside the storage bag that came with the material carrier.
1. Unload material from the printer.
2. Locate your 2 material retaining clips on the carrier. See Figure 27 .
On
●
Material currently loaded to the head
Off
○
No carrier present
Carrier present and ready to be loaded
Blinking
☼
Carrier needs replacement (is empty or has an error)