Still OPX 20, Supplement To The Standard Operating Instructions, Page: 98 / 140

Lifting and lowering the fork carriage
In
Assistance
mode, the operator controls
the lifting functions via the remote control or
by using the keypad on the side of the truck.
Lifting or lowering starts with a short delay, ac-
companied by a signal tone. An increase in
the frequency of the signal tone warns the op-
erator to keep his feet away from the area un-
der the forks.
The OPX-L 20 S can approach six fixed lift
heights. The authorised service centre can ad-
just the intermediate lift heights and the end lift
height to meet customer-specific requirements
(from 01/2021 onwards).
WARNING
Risk of feet being crushed when lowering
–
Keep feet away from the area under the forks.
–
Pay attention to the increase in the frequency of
the signal tone.
Truck type Button
1
(lift) Button
2
(lower)
OPX 20/25 (initial lift)
● Hold the button down:
The fork carriage comes to a
stop when the button is re-
leased
● Briefly push the button:
The fork carriage stops after
1 sec.
● Hold the button down:
The fork carriage comes to a
stop when the button is re-
leased
OPX-L 12 (main lift)
(1)
OPX-L 20 (main lift)
(1)
● Hold the button down:
The fork carriage comes to a stop when the button is released
● Briefly push the button:
The fork carriage stops after 1 sec.
OPX-L 20 S (main lift)
(1)
● Long press the button (min. ½ sec.):
Fork carriage moves to the upper/lower end position
● Briefly push the button:
Fork carriage comes to a stop at the next defined lift height
(1)
On trucks with a main lift, the lowering procedure automatically stops at 300 mm.
● To lower the fork carriage further, push and hold the "Lower" button again
● The fork carriage comes to a stop when the button is released
● In the OPX series-production truck, the initial lift is controlled in the truck cockpit
2 3 1
1
2
2
1

Operating the iGo neo
4
Operating the truck in "Assistance" mode
90 50108046112 EN - 07/2020 (03)