Still OPX 20, Supplement To The Standard Operating Instructions

Page: 52 / 140

the truck. The scanning height is approx.
9 cm.
The safety laser scanner detects stationary
objects on the ground that have the following
minimum dimensions ( on the illustration):
●
Diameter: at least 70 mm in scanning height
(on the side facing the safety laser scanner)
●
Height: at least 200 mm
If the safety laser scanner does not detect an
obstacle because these required dimensions
do not apply, the truck could ram the obstacle.
For this reason, it is necessary to pay special
attention to the following obstacles ( on the
illustration):
●
Obstacles that are too low to be detected by
the safety laser scanner
●
Obstacles that do not reach down to the
floor
Obstacles of this nature could include:
●
The load on a pallet that protrudes into the
roadway above the scanning height of the
safety laser scanner
●
A bar in a rack that protrudes into the road-
way above the scanning height of the safety
laser scanner
●
Hand pallet trucks and their tillers, or the
forks of trucks
●
A cable that hangs crosswise to the road-
way
●
Ladders and mobile workshop hoists that
protrude into the roadway
●
An object that is too small or too narrow to
be detected by the safety laser scanner
(e.g. a narrow rack support or the leg of a
chair)
Overhang for obstacles
If the iGo neo is used in the vicinity of trucks
or objects with an overhang (1), an increased
safety distance is required.
The authorised service centre can set a safety
distance, (X), which takes the overhang of
trucks or objects into account.
1
X

Components of the iGo neo
3
Laser scanner
44 50108046112 EN - 07/2020 (03)