Still OPX 20, Supplement To The Standard Operating Instructions

Page: 66 / 140

After releasing the emergency off switches
and restarting the system, the movement
tracking sensors must show "
Assistance
mode PAUSED".
Function checking of the foot protection
sensors after switching on "Assistance"
mode (OPX-L 20 S)
After switching on
Assistance
mode, the
operator must check that the two side foot pro-
tection sensors are working. If the foot protec-
tion sensors detect an object under the forks,
the truck does not move off or responds with
an emergency stop. However, the operator
can still lower the forks.
The foot protection sensors are only installed
in trucks with a pantograph lift (OPX-L 20 S).
They are located on both sides next to the
lower fixing point of the pantograph lift on the
truck.
The yellow display LED on the foot protection
sensor (1) lights up when an object is detected
in the area below or next to the forks.
–
Lift the forks approximately 20 cm.
–
Walk in the area to the right of the raised
forks and observe the display LEDs on the
foot protection sensor.
–
Place one foot parallel to the fork in the
area next to the fork. Do not lower the fork.
When the foot protection sensor detects
your foot correctly, the yellow display
LED lights up.
–
Repeat the test on the left side of the truck.
Visual inspections after switching on
"Assistance" mode
After switching on
Assistance
mode, the
operator must check the following truck func-
tions during operation:
Visual inspections when
Assistance
mode is active
● Check that the truck responds correctly to entries made with the remote control
● Check that the warning signals and information signals function in
Assistance
mode
(1)
1
Function checking of the foot protection sen-
sors
Foot protection sensor with yellow display
LED
1

Operating the iGo neo
4
Checks and tasks to be carried out when commencing "Assistance" mode
58 50108046112 EN - 07/2020 (03)