Positioning the truck correctly in the
aisle
Positioning the truck in the aisle
It must be possible for the truck to detect a
straight rack contour.
The rack contour (distance between the rack
uprights) must not have any gaps larger than
2.7 m (can be parameterised). Larger gaps
are detected as a crosswise roadway.
It must be possible for the truck to detect the
rack contour (1) over a distance of 2 to 3 m
in front of the truck.
The truck must be positioned parallel to the
rack.
Specifying the distance to the rack con-
tour
The truck retains the distance to the rack con-
tour that it had when switched to
Assis-
tance
mode ACTIVE. This distance is set
when the operator leaves the driver's platform.
–
Drive the truck manually to the starting point
for
Assistance
mode.
–
Position the truck at the required distance
parallel to the rack. The selected distance
(2) must be between 50 cm and 250 cm. If
an insufficient distance is specified, the
truck will steer until a distance of 50 cm (or
a larger fixed distance) is reached.
–
Leave the driver's platform. If necessary,
switch to
Assistance
mode ACTIVE.
The truck follows the rack contour at the
specified distance.
NOTE
The authorised service centre can configure a
permanent distance to the rack contour.
min. 2 - 3 m
min. 50 cm
max. 250 cm
1
2
Operating the iGo neo
4
Operating the truck in "Assistance" mode
77
50108046112 EN - 07/2020 (03)
Summary of Contents for OPX 20
