Stiegelmeyer Evario, Instruction Manual, Page: 74 / 168

Instruction manual for Evario hospital bed
74
Switching ON/OFF and reprogramming intermediate stop
This function is factory programmed to, and switches off at, an angle of 30°.
If necessary, this function can be activated on the handset and on the control panel (on the
outside of the Protega safety side) and the intermediate stop angle reprogrammed as re-
quired.
Switching ON/OFF:
1.
Switch to the “medical staff control level”
(handset: Hold the end of the handset briefly against the magnetic unlocking key.
Control panel (outside): Press the settings button).
2. Select the icon or use the toggle button to make a selection, and
acknowledge your selection with the UP button
Re-programming the intermediate stop angle
1. Set the intermediate backrest stop to the desired position.
2.
Switch to the “technician control level”
Handset: Refer to steps 1-3 of Chapter 8.8.1 for instructions on how to switch to the technician
control level.
Control panel (outside): Press the UP and DOWN buttons and keep them pressed, then press the
SETTINGS button briefly in addition. Finally, keep the UP and DOWN buttons pressed for a further
5 seconds.
3.
Select the icon or use the toggle button to make a selection, and acknowledge your
selection with the UP button
An acknowledgement beep sounds for one second
The original position is overwritten
When the intermediate stop function is activated, the backrest stops in the intermediate
stop position that has been set. To continue, release the UP/DOWN adjustment button and
then press this button again.
9.5.2 On the Control Box
1 Press the backrest UP button and the unlock button at the same
time to raise the backrest.
2 Press the backrest DOWN button at the same time as the unlock
button to move the backrest back to the normal position.