4-9
Operating Instructions
Operator Manual
122993-622
4.8 Shutdown
Procedure
At the end of a work session, the washer should be shut down and cleaned
thoroughly. Refer to
Section 6, Routine Maintenance, for complete cleaning
instructions and scheduled minor maintenance.
1.
Access Manual Control mode and drain tanks as explained in
Sec-
tion 4.7.3, Tank Dump.
2.
Position
POWER-OFF/STANDBY
switch to
OFF/STANDBY
.
3.
Position building electrical disconnect switch (circuit breaker) to
OFF
and
close building supply valves.
4.
Clean unit as described in
Section 6.3, Daily Cleaning Procedures.
5.
Ensure building electrical disconnect switch is positioned to
ON
after
completion of cleaning and minor maintenance procedures.
NOTE: Leaving disconnect switch in OFF position overnight will shorten life
span of battery backed-up control memory.
A proximity switch, located at the end of the optional discharge conveyor,
stops the conveyor drive system when an item reaches the end of the conveyor
(see Figure 4-2).
4.9 Proximity
Switch Conveyor
Stop
WARNING – BURN HAZ-
ARD: When unloading pro-
cessed items from conveyor,
wear appropriate Personal
Protective Equipment
(PPE). Clean items may be
extremely hot or contain hot
rinse water.
W A R N I N G – S L I P P I N G
HAZARD: To avoid slippery
floor conditions, immedi-
ately wipe up any spilled
liquids or drippage. If
spilled liquids or drippage
are detergents or other
chemicals, follow safety
precautions and handling
procedures set forth on
detergent or chemical label
and/or Material Safety Data
Sheet (MSDS).
Figure 4-2. Optional Discharge Conveyor
Optional Discharge Conveyor
(by Gravity or Powered)
Basket Barrier
Proximity Switch
EMERGENCY STOP
Pushbutton
