3-8
122993-622
Operator Manual
Component Identification
Hydraulic hold-down system allows control of the water pressure exiting the spray
jet systems during cycle operation. By decreasing the water pressure to the lower
spray jets, the downward pressure from the upper jets will hold the product down
on the conveyor (see
Section 6.15, Adjust Hydraulic Hold-Down System).
System includes balancing valves installed in the water supply lines, located inside
the wash, rinse and final rinse chambers, on opposite side of chamber from the
access door (see Figure 3-8). Balancing valve is a ball valve with a blue handle.
3.8 Hydraulic Hold-
Down System
WARNING – BURN HAZ-
ARD: Do not adjust balanc-
ing valve while washer is
operating.
3.9 Garb-el Control
Panel (Option)
The Garb-el control panel is used to direct Garb-el functions (see Figure 3-9).
•
GARB-EL AND DRIVE SYSTEM STOP
- pull to operate Garb-el and push
to stop Garb-el and washer belt drive.
IMPORTANT:
When Garb-el is placed in OFF position, feeder mechanism
stops instantly but water and pulverizer mechanism continue to run for up to
five minutes to provide extra flushing of the waste line.
•
GARB-EL SYSTEM ON/OFF
- position to ON to run Garb-el. Feeder
mechanism and pulverizer start simultaneously.
Figure 3-9. Garb-el Control Panel
GARB-EL AND DRIVE
SYSTEM STOP
GARB-EL SYSTEM
OFF
ON
Figure 3-8. Spray System Balancing Valve
Balancing Valve
