4-5
Operating Instructions
Operator Manual
122993-622
• RINSE
Heated water from the rinse sump is pumped through the spray header
over and under the load, then falls back into the rinse sump to be
recirculated.
• FINAL RINSE
Hot water from building supply is fed through an instantaneous heat
exchanger, through the final rinse spray header, and falls into the rinse
tank.
NOTE: If temperature guarantee feature is selected for the Final Rinse,
the display shows a G after the Final Rinse temperature. The belt only
runs if the temperature is greater or equal to set point.
•
DRYING (OPTION)
Hot air recirculates through drying section. An air knife blow-off system
removes surplus water from washed items.
1. Press
STOP/RESET
touch pad to immediately halt operation of cycle in
progress. Display indicates cycle was stopped:
PRESS STOP TO ABORT
OR START TO RESUME
and printer message is:
*CYCLE PAUSED
HH:MM:SSP
2. Press
CYCLE/START
touch pad to resume cycle operation. Display shows:
ALK. TEMP =
XXX.X F
ACID TEMP =
XXX.X F
and:
RINSE TEMP =
XXX.X F
FINAL RINSE =
XXX.X F
and printer message is:
*CYCLE RESUMED
HH:MM:SSP
4.5 Stop Cycle
STOP
RESET
CYCLE
START
